Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on nexus design with fabricpath , currently we have more than 5 pairs of 6500 VSS and we have backup media servers for every pair so that traffic will be local to that pairso we when we migrate to Nexus fabricpath, servers can be any...
I trying to Network deisgn for new data Center , i am new to DataCenter desgin, i attached the network diagram i would like to know if can configure my layer3 on 5500 and configure Fabric path to uplink switchplease help give your suggestions on thi...
I have T1 provided by the Telecom group to connect to Call Manager express, Can i connect to a FXO card or Wic T1 cardi have following hardware on the router 2 FastEthernet interfaces1 Serial interface2 Serial(sync/async) interfaces1 terminal line1 ...
Trying to enable Qos on 4507RE,when i typed command on interface(config-if)#auto qos voip cisco-phoneiam geeting following error The policy AutoQos-VoIP-Input-Cos-Policy cannot be attached to the interface Gi2/41 since it has 'set' actions. IP Routin...
i have UC520 with the following configuration will it be possible to connect Cisco UC520-8U-4FXO-K9 (MPC8358) processor (revision 0x202) with 249856K/12288K bytes of memory.Processor board ID FHK133975NAMPC8358 CPU Rev: Part Number 0x804A, Revision ...
Hi derek I saw you reply , do i need to do anything other than above configuration do i need any files on the TFTP server for polycom, i am trying to configure polycom 560Thanks Sri
