cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1224
Views
5
Helpful
7
Replies

Route Group distribution Algorithm

Nkechi Latunji
Beginner
Beginner

Hello

 

I have two SIP gateways (GW1 and GW2 in this order) in a route group configured for Circular distribution algorithm. What do i need to configure to make sure that when GW1 LAN or SIP trunk to ITSP is down, outgoing call that were bound to use GW1 will now used GW2 with the shortest amount of delay possible to route the call.

 

Thank you 

3 Accepted Solutions

Accepted Solutions

tgaur
Cisco Employee
Cisco Employee

Hi

you can configure option ping on CUCM, so that the moment CUCM not getting replies of option message it will treat the gateway is down and not even attempt to send setup out to the gateway, and will skip to next member in RG immediately.

Regards
Tarun

View solution in original post