Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, Help me figure this out caller ID issue: There is a I CUCM 8.6(2) with a 2911 MGCP gateway. I have an E1 card inserted into the GW and from my PSTN provider I receive 6 digitis (707000 - 707149). With a transformation pattern applyed I ma...
Hi guys, I have a customer that has the following issue: Few months ago made an upgrade to their Call Manager from version 4.1 to 7.1.5 and added more DID numbers, but not from the same range of numbers. When a call come from PSTN to extension 1...
Hi guys, I have a need to power up some new 1262N access points at a 150 m distance from the switch. Would work if I'll do like in the picture bellow?Best Regards,Michael
Hi Guys, I have a DMM 5.2 and 5 DMP's 4400G with 5.1 version. I can't find the 5.2 firmware on the Cisco download page. If someone could please give me the link to the 5.2 firmware. Thank you!
Hi guys, I am running a CM 7.0 in vmware for lab testing. Today I wanted to upgrade to the latest version and decause didn't let me upgrade directly from 7.0 to 7.1(3a), I upgraded to 7.1(2b) witch success and made a reboot after finish. Then when ...
Hi stavropouloss, In order to that service become active you need to have the Traversal Zone between Expressway C & E active. To have Expressway C & E traversal zone active you need to upload on each server certificates signed by a trusted CA...
Hi Håkon, Thank you for the reply. I enabled the URI dialing as you suggested through jabber-config, and now it's working for me also. Regards, Michael
Hi Haakon, I have the same problem with URI dialing as you do with the new Jabber 9.6. Be sure to use the 9.1.2-11900 version of CUCM as requested in the server setup guide. If you discover how it works, please let me know.Regards,MichaelSent from Ci...
Hi rcarricato, I found your post while browsing for an outdoor wireless solution for voice. Have you managed to find if voice is supported onto 1550 mesh access points?If not, what other options are available besides 1300 APs running in 2.4 GHz?Th...
Hi, I have also tested the dialpeers, and they work perfectly.If I setup a Cisco phone with 845 number on the call manager, I receive the call from PSTN.If make a test with csim start 845 the dect phone ring, but it doesn't want to ring if I call fr...
