Hi, I understand from Cisco that the NCS 5k platform has an ECMP group limit of 4096.   I'm struggling to determine what limits there might be for other platforms such as an ASR 1k for example.   Has anyone run into this before ? Thanks. Matt.

Hello, Been working on a Cisco 2811 setup as a UBE device to terminate a few different voice techs (PRI and SIP), and send them via SIP to an IP-PBX. I'm running into problems where the CUBE will immediately disconnect a call when you lift a handset ...

Hi, I'm reading the ifXTable with SNMP on a 7600.  If I configure a VIEW to exclude the entries I don't care about  within the ifXTable, am I achieving any efficiencies from the routers point of view ?  In other words,  does the 7600 still build the ...

Hi There,For over 2 years i've been running a CME 4.2 router happily.   I have a number of different hunt groups and users are able to login and out fine using the Hlog soft key.   Today I have a group of users unable to receive calls via a B-ACD ser...

Hi,Just looking for some upgrade advice.I'm currently running UCM 6.1 and UCCX 5 with success.  No real issues.I believe I am eligable  for upgrades on both but should I bother ?  I hear about version 8 and its Vmware compatability etc.   I could go ...