Hi!!   I have a gateway with mgcp configured to a CCUM. Everything is working fine but when a reboot is made or a power cut is done the ccm-manager stays down until I do the command "no mgcp" and then "mgcp". My CCUM is 12.5 and my gateway uses 16.11.01a.   Some configs are:   " mgcp mgcp request timeout 1000 mgcp call-agent 172.17.50.130 service-type mgcp version 0.1 mgcp dtmf-relay voip codec all mode out-of-band mgcp modem passthrough voip mode nse mgcp modem passthrough voip codec g711alaw mgcp package-capability rtp-package mgcp bind control source-interface GigabitEthernet0/0/0 mgcp bind media source-interface GigabitEthernet0/0/0 mgcp behavior rsip-range tgcp-only mgcp behavior comedia-role none mgcp behavior comedia-check-media-src disable mgcp behavior comedia-sdp-force disable ! mgcp profile default ! sccp local GigabitEthernet0/0/0 sccp ! ccm-manager music-on-hold ! ccm-manager fallback-mgcp ccm-manager mgcp ccm-manager config server xxx.xxx.xxx.xxx ccm-manager sccp local GigabitEthernet0/0/0   controller E1 0/1/0 clock source line primary pri-group timeslots 1-31 service mgcp ! controller E1 0/1/1 clock source line secondary pri-group timeslots 1-31 service mgcp interface Serial0/1/0:15 no ip address encapsulation hdlc no cdp enable isdn switch-type primary-net5 isdn incoming-voice voice isdn bind-l3 ccm-manager trunk-group ALL_PRI ! interface Serial0/1/1:15 no ip address encapsulation hdlc no cdp enable isdn switch-type primary-net5 isdn incoming-voice voice isdn bind-l3 ccm-manager trunk-group ALL_PRI "     Can you help on put this working in automatic mode?   Best regards,   Jose Carlos ... View more

HI!! Need your help on this; I have a customer with CUCM 9 that need that a DID rings on a group that after some time rings on set A, then set B and finally on a external mobile set. I tried to create a cti route point but the Hunt group does not follow the forward configuration even if it goes to voice mail; tried to configure SNR but since I don't have a physical phone installed it does not work (busy tone all the time because dummy phone is not registered). Customer does not want to have a physical phone only to do this.   So, what can I do to give a solution to the customer; can any one give me a clue? On other brands I do this easily; unfortunately hunt group does not follow forward configuration :(   Best Regards, Jose ... View more

Hi!!   If I access my CUCM from the VMware Console the keyboard layout is on US; is there a way to change to the correct country? I used the PCD to migrate to the latest release. This is useful because of users that use special characters on the password and fail all the time to login on the console VMware.   Best Regards,   ... View more