Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to do to swap out my N2K-C2248TP with N2K-C2248TP-E. All my searching has turned up nothing regarding a procedure to achieve this. Are these similar enough models that I can just swap them out without having to re-provision the different mode...
We have recently moved to CUCM 11 from an old Avaya system. A hunt pilot of 6441 was created and is working without issue inside the building. That extension used is a DID and not accessible when calling the DID. Is there a way to make a Hunt Pilot a...
I'm sure this is a simple one but it is beyond me at the moment. I have a host on an inside interface that is going out NAT'd behind the outside interface of an ASA trying to gain access to host on that same outside interface via an ARIN address we h...
I have setup an active LACP consisting of two members in each port-channel. As it is configured now the individual ports are operational but not participating as members of the LACP. Not finding any reference to exactly why this is. From what I can g...
Hello Cisco Community! I'm hoping someone out there can confirm my diagnosis. Still a little green when it comes to this kind of thing. IssueIntermittent connectivity to Vlan105 from all other Vlans and slowness between hosts in Vlan105. DiscoveryST...
So I finally got to test this a few weeks ago and ran into a slight wrinkle. Swapped FEX111 from a N2K-C2248TP-1GE to a N2K-C2248TP-E-1GE. It appeared to be going through the usual download and rebooting for the image but never came up. I had to adj...
Other DIDs are working including those in the same range is this 6441. Hunt Pilot 6441 is assigned the same partition as these DNs are working without issue.
