Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI forum, Has anyone experienced importing from COBRAS into a CUC v14.I have installed the Informix ODBC Drivers as required on the Server I am running COBRAS on but I constantly get an ODBC error when trying to connectI have created a user with remo...
Hi All.
I am trying to get a pair of Nexus 7702's to join multiple HSRP groups already configured on a pair of CAT 6006's RSM's.
We have made sure all the timers are the same and that the HSRP version is v1. We have also added authentication to the ...
Hi all, I have discovered a bug in switch software c2960x-universalk9-mz.150-2a.EX5.binThe type of switch I have is C2960X-48LPS-LIf I have the command "login on-failure log" configured and type the password wrong it reboots the master in the cluster...
Hi.I think this may have been asked before but its not clear to me.I have 2 4500-X configured as a VSS pair, so a VSL link of 2 x 10Gig between them.I have a number of Access stacks, built from 2600-X'sI have tried to configure dual active detection,...
Thanks Roger, Sorry for the late response.Yes I had the IP addresses in correctly.I think I had to start another service, but I had so many issues with v14 on CUC, CUCM, IMP that its all kinda a blur so not sureI have the servers built and working fu...
Hi Mike, I have the same issue.I also restarted my server and now when I try to log in I get prompted for a registration certificate.When I download the cert from the portal and install at the requested pop up, I get the following message. Hopefully ...
HI Rob,
Found this thread, after just upgrading some 7821's with this version of phone load. Some upgraded fine but 1 didn't. I thought it was possibly the phone version, there were some v1's v2's and v3's. The failed phone is a v3, but another v3 up...
