I have recently added a second SIP trunk to a CUBE and need to fully test outbound dialing on the trunk. The CUBE will receive the call setup from CUCM 11.5.1(SU6) without issue, but it is matching the Dial-Peer that points to the legacy SIP Trunk. ...
When utilizing CAPF for 802.1x authentication for a phone, is it required to generate a CAPF certificate on all nodes of the cluster, or only on the publisher node?
I'm running IM&P version 9.1.1.20000(5) and have a mix of clients from 9.1.1 to 10.6.2. I am wondering if there is a report that I can get detailing the users and the client version they last logged in with?
Is there a mechanism that will allow me to delay the redistribution of routese from BGP>OSPF and OSPF>BGP until the BGP Peer has been established for a set period of time, say 15 minutes? this would also need to account for a "flapping" peer and res...
Is there a mechanism that will allow me to delay the redistribution of routese from BGP>OSPF and OSPF>BGP until the BGP Peer has been established for a set period of time, say 5 minutes?
I'm having this same issue.Setup Cat 4507, IOS 12.2(50)SG1 Routed Interface. Using jperf to test a new pt-pt link and sending 95Mbps for over 5 minutes. Load-int = 30. The packet count is incrementing, the in/out bits/sec are not showing anything...
Joeseph, Thank you immensely for your assistance on this. I was making it out to be more complicated that it needed to be. Thanks for clueing me into the environmental varialbe for the "--Anthony
Not sure what you mean. Here's my script:event manager applet BGP-UP-STABLE event tag BGP-DOWN syslog pattern "%BGP.*neighbor 10.0.0.114 Down" event tag BGP-STABLE snmp oid 1.3.6.1.2.1.15.3.1.16 get-type next entry-op gt entry-val "120" poll-interv...
Thank you for the reply. I'm new to EEM and quickly learning the power of this tool. Ive written an applet to remove the redistribute commands Triggering on a syslog event of %BGP.*neighbor 10.0.0.114 Down The problem Im having is getting the redist...