Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on this design where the DC VLANs that need to be extended to DRC via OTV have their gateways as SVIs on a server agg VSS. So there is no FHRP in DC. The other side (DRC) server aggregation is a pair of VDCs on N7K. See figure for connec...
Hi, we upgraded from WCS 7.0.176.0 to 7.0.220.0 to make use of the enhancements to the DB engine.However, we are faced with a problem when we run the AP Summary report. We customized the report to be very basic as seen in the attached image. We only ...
We are migrating from CWLMS 3.2 to 4.0. After successfully fresh-installing the 4.0 software on a new server, which is in a production environment protected by a host-based firewall and a network firewall.Once we access Topology Services, we get two ...
We want - based on customer requirements - to protect the outdoor APs and the infrastructure behind them from transient voltage surges and near-miss lightning.I read in this forum that it is better to protect the infrastructure behind the APs by inse...
We have a setup of two WiSMs (4 WLCs) in the HO and multiple branches connected to theHO through MPLS with the same ISP.In one of the branches, the APs are unable to join any of the cotrollers. Itroubleshooted this issue from different aspects with n...
I have the same issue here. The session slot command worked fine during initial config and after HA was enabled. Once I upgraded to 7.6 the "session slot" commnad stopped working. Any solutions?I am using static IP addresses for active and standby WL...
Have a look at this post and let me know if it works for u. Dont forget to mark as correct answer if it is. https://supportforums.cisco.com/thread/2152534
I am running into a similar situation with one of my customers. Did you reconsider this design? Wondering if we can pair a Nexus 7009 switch with a Nexus 5548 as vPC peers?
I am having a similar concern. We want to allow the guest user to access a portal website prior to being authenticated. As I understand, we must create a pre-auth ACL to allow DHCP, DNS, also we have to allow http to the portal IP addresses.From your...
