Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a customer with a secured network, using Checkpoint firewalls and have a VPN site-to-site tunnel between our Cisco ASA and their Checkpoint firewall, with Cisco phones on the far side of the tunnel and CallManager 8.6 behind the ASAs. We hav...
I am looking for a quick and validated Cisco response on this, if you can provide it today.Customer is Federal and I am implementing Jabber integration with Exchange 2003 for Calendaring Presence and the current build docs say that only NTLMv1 is cur...
I have a customer that is wanting to integrate there production CER 8.0 with a new RedSky solution. The RedSky solution is designed to allow us a translation number out the PSTN as a long distance call. The problem that I am encountering is, at wha...
I have a customer that opted to go with a 4-digit numbering scheme, rather than a 5-digit and they have nearly depleted the available non-DID extensions for an upcoming phase of rolling out CER. They want to do approximately 1300 ERLs (zones) and ha...
Hey All - I have a concept that is holding up an enterpirse rollout I am involved with and really need some expert feedback.I have a customer that has temp teachers that will log into phones in a classroom they are working for the day.Each classroom ...
If your CallManaer is LDAP-integrated, I would check to see that the ipPhone attribute matches the number of digits you have configured on your CSF device. We found that, if we had CSF (Jabber) devices configured with 7-digits and the ipPhone attri...
A related question: I am deploying for a site with 8.6(1) and customer inadvertently isntalled the BFCP COP file. Will Desktop sharing still function, or, knowing that COP files cannot easily be uninstalled, should I advise them to reinstall or is ...
You may have to eliminate the Hunt Pilot config and just configure this between the CFB / CFNA settings between the 2 phones themselves, and, on the 2nd phone, just CFB / CFNA to your VM-only DN. I would try just deleting all this setup and go that ...
This issue as come up in the past, on a previous forum posting here:https://supportforums.cisco.com/servlet/JiveServlet/download/1162838-32462/The SIP Firmware version is a bit older, but the programming steps for the Nortel phone are the same.
