Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have recently migrated out CUCM voice estate to Webex. All DDI numbers have been ported over to the Webex service. All users set up with Cisco 8861 & 78xx series phones. We have experienced issues where phones may be connected on the same LAN with...
I am facing a problem with our Call Manager Setup.
Our voice setup is delivered a pair of Cisco Cube, that send calls onto our Call Manager (v10) that comprises of 4 subscribers.
When external calls are received on the cubes they pass the calls onto ...
I am currently experiencing a fault when trying to enable extension mobility on a Cisco 6921 handset. We recently upgraded our CUCM from v8.5 to v10.5. There were no connection issues when extension mobility was enabled on a Cisco 6921 handset when r...
Hi All,We are currently using CUCM V8.5.1We have recently setup a gateways (Cisco 2901) that connects to a third party CTI server.For resilience we have this setup duplicated in a DR comms room.Each of our gateways are full MGCP controlled with a dig...
I am looking to add a new 3750 Switcch to an existing stack shown belowSwitch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 26 WS-C3750-24P 12.2(35)SE5 ...
Hi Manish,
If the translation pattern is set up as 01111 111XXX, (1'000 DDI's) and we are only using half of the DDI's in that range. The only issue that we have is that the numbers used are spread throughout that range.
If i set up the blocking pat...
Hi Mohammed, are you able to expand on the process on how to generate traces from extension mobility service in CUCM during the login process.CheersMartin
Thanks for all the replys I did try and downgrade the IOS on the new switch - no joy there.Unfortunately there is not a switch in stock to add to the new one to determine compatible IOS version for legacy and V2 3750 switches.I will look to upgrade t...
Thanks for your reply Christos.You have given me a start on what to look at on this one, will have to have a discussion with firewall guys once i realise what is required.Much appreciatedMartin
Thanks for the reply to my question Rob and German.I was trying various ways to try to achieve my goal but was getting no where.Just thought it would be easier for end users to hit a soft key to access EM rather than navigate to this option.Will have...
