Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just changed out some SCCP phones for newer SIP 8851. Everything works, but have crazy issue with call park. Call park works fine IP phone to IP phone. When a call comes in the MCGP gateway via PRI. I Park the incoming call no issue. Retrieve the par...
I have a Multilink with two T1's in the bundle. Been having a weird issue. The multilink will work fine for a few days. Then I will just start dropping a lot of packets. I have contacted my MPLS provider. They see no issue with the circuit. While the...
Hello,
I'm performing an upgrade of callmanager, unity, and IM&P. Going to try and use the PCD Tool. My question is this. I'm currently running version 8.6
upgrading to version 10.5. My current 8.6 machines are already virtual. They are running on th...
Hello,I currently running Callmanager version 8.6 Attendant console server 8.6, and the Attendant console client version is 8.6.Having some issues with Qos. I have a remote site that runs a multilink connection. I have a policy-map in place that wor...
Well I pulled debug isdnq931 off of gateway. Seems as if the telco is disconnecting call. Just don't see how this could be a telco issue. I've seen stranger things though.*May 8 14:07:12.372: ISDN Se0/1/0:23 Q931: TX -> NOTIFY pd = 8 callref = 0xC56...
Thanks Hitesh,I had read most of the doc’s already. Since I could not find a for sure answer on the ports. I just created an ACL and matched all traffic going to the AC server. Seemed to have fixed my issue.
In the document I do not see your access-list. This is the way I normally do it.Ip access-list extended natlistdeny ip any what ever you inside is.permit ip any anyroute-map dslnat permit 10match ip address natlistmatch interface your outside interfa...
