About wilmer_1282004

wilmer_1282004 · 08-06-2015

Hi,I am trying to install a DX80 firmware and it fails on the file verification where it says the file is invalid. As mentioned in the guide, i have installed the device pace - cmterm-devicepack9.1.2.14089-1.cop - for CUCM.I tried to download couple ...

wilmer_1282004 · 07-02-2015

Hi,If i have 2 Unity Connection Servers running HA of each other, is it normal that the other one will not show backup? i have tried restarting DRF service and restarting the server which has the not responding status but still getting the same after...

wilmer_1282004 · 04-06-2015

Hi,Hard Phones are showing incorrect time - ahead by 30mins. Checking CUCM servers shows that DTG setting is correct (GMT+8). NTP is configured in CUCM and is polling time from our VOIP Gateway. Now, VOIP router clock is incorrect although NTP server...

wilmer_1282004 · 03-30-2015

Good Day,I am not getting ringback on some numbers but others work. Numbers reside in the same country. Can you tell if this is a Telco issue? Below are the part of the debug isdn / ccapi of working and non-working. I can reach the non-working number...

wilmer_1282004 · 03-17-2015

I am trying a new setup. There are no other phones on branch A configured with CUCM so there is no comparison. I setup another phone in Branch B for comparison.Scenario:CUCM (ver9) in Main siteMain Site and Branch A site has VPN for WAN connectivity....

wilmer_1282004 · 10-30-2019

Hi Wayne,Could you verify if you have C240 M4 hardware or C240 M5? The release notes for ver 4.0(4) doesnt seem to list M4 platforms as supported - https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/release/notes/b_UCS_C-Series_RN_4_0_4.html...

wilmer_1282004 · 07-02-2015

Thanks Terry. I go to DRS of each to do the backup and Pub got the status "Local Agent not responding" and no backup history and manual backup can be done. You did answer my question though and now i will have to find out how to enable backup on Pub....

wilmer_1282004 · 07-02-2015

Thanks Terry but you got me confused there.Based on the bug link and what you said, Pub and Sub needs separate DRS Backup, then having the Not responding status on one of the servers is not a normal behavior then. Am i missing something?Wilmer

wilmer_1282004 · 04-08-2015

Thank you for your reply Leo.If i remove the NTP master 4, Clock never synchronize saying no reference clock. After further research, it was because of the NTP source loopback command. Following the route to the NTP servers it goes to our Data route ...

wilmer_1282004 · 03-31-2015

Thanks Alex,(+5) for the thorough explanation of interpreting the logs. It is then a best practice to always add these commands.Cheers,Wilmer

Member Since	‎09-06-2007 04:55 AM
Date Last Visited	‎11-06-2019 02:19 AM
Posts	32
Total Helpful Votes Received	15

User Statistics

User Activity

Installing DX80 Firmware failure

One of 2 HA Unity server is not showing backup

NTP question

No ringback tone for some numbers - Telco issue?

Branch phone no audio when making outbound PSTN call - inbound and On-Net calls are good

Re: C240 M4 Email Alert FROM Address

Thanks Terry. I go to DRS of

Thanks Terry but you got me

Thank you for your reply Leo

Thanks Alex,(+5) for the