Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
We have a newly configured SIP Trunk between a SIP PBX and Cisco via CUBE.
Inbound and outbound calls are working fine.
Our issue is after the call connects, the caller can only see the display "Outbound Call".
No matter if the call came f...
Hi Guys, We have a customer with a CM version 6 and they currently have an intermittent issue with incoming call.Since it has a CM ver 6, we're unable to open a TAC case. We need to verify if some can shed some light with what these errors mean? Call...
Hi Everyone,We have a setup of one deskphone and Cisco WebEx connect for each user on a site.The deskphone and WebEx connect has a shared line. Everytime a call comes in on the the extension number and the call was answered using the deskphone, a mis...
I agree with Dennis. Just remember to take care setting up ACL and don't forget the implicit deny ip any any.
Also regarding the test, not sure if its implied in your list but I commonly do the call features (e.g. hold, transfer conference) twice. I...
Hi is it possible to run a debug on the CUBE router?
Can you paste debug voip ccapi inout here so we can check if CUCM is sending the call to the CUBE and if CUBE if sending the call to PSTN. Thanks
Hi what's the MAC address of your remote phone 7821?
I suggest to isolate by trying to setup a CIPC using SIP in the remote site. You can collect packet capture from a machine with a CIPC.
Hi Mohammed! Apologies for the late response. Yeah actually I opened a TAC case for this and confirmed that the feature is not supported with CIPC. Thanks Mohammed!
Hi had the same issue before and tried changing the SIP timers. but what solved our issue was disabling the built in bridge inside the device page.
You can check CSCut37922
