Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I have a C220 M3 server that is running one of our CUCM subscribers and Unity Connection subscriber. I noticed today that it has an Amber light on the chassis. I have looked in VCenter, the ESX host screen, and even the Call Manager applica...
Hello,I have several Cisco 2811 routers at my branch locations. Most of them are running 12.4(24)T5 and I am looking to upgrade the IOS as part of a refresh/standardization project. I would like to move to the most recent STABLE IOS available. I do n...
Hello,I have several 3560X series switches all running on 15.0(2)SE2, but there is one switch in particular that crashes every 5 weeks (almost to the hour). I have attached a crash file that I cannot decode. Can anyone tell me how to figure out what ...
Hello,I have recently upgraded the IOS on my 3560X to 15.0(2)SE3 and I am having trouble getting TACACS to work correctly. This was working correctly on this device before I upgraded the IOS so I am not sure what happened. I made some other changes a...
You will need a specific dial peer for your situation. What number are you dialing in order to dial outside numbers? Your destination pattern will need to include the exit digit as well as 10 digits or wildcards. For example: "destination-pattern 9.....
I know this is an old post but I found it helpful and I wanted to say thanks! I had been looking in the Call Handler transfer rules to try to disable this message. It was actually on the destination user transfer rule that I had to un-check the "Wait...
I would do the following:1. Create a new Directory Number (Not the same as the Hunt Pilot) then set it to forward immediately to voice mail.2. Add the new Directory Number into the Line Group as the last member.3. Add the new Directory Number to the ...
I agree with Joseph. Less than 1% output drops should not be harmful to your network.In my case, I did not even notice there were any output drops on my network until we deployed Solarwinds. I fought with this for months trying to eliminate these out...
I do not use the setup wizard, so I cannot address that. Typically, the management IP is the address you will use to access the device. The main VLAN address will probably be your default gateway for the devices on that VLAN. It is true that they cou...
