Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Can some one please confirm whether we can enable the stacked vlan features on 7206vxr NPE G2?
int gig0/1.xxx
encapsulation dot1q XXX second-dot1q XX
Thanks
Hi Guys
does anyone seen the below behavior on CUBE?
i have configured dial-peer as below
dial-peer voice 2 voip description SIP TRUNK OUTGOING huntstop preference 1 destination-pattern 99T session protocol sipv2 session target ipv4:172.X.X.X:506...
I am not able to apply 4 byte AS as below on 7200 image . Any help here please
Image :c7200-advipservicesk9-mz.122-33.SRE14.bin
NPE-GE
Error as below:
Router(config)#router bgp 135296Router(config-router)#bgp asnotation dotRouter(config-router)#exitR...
Hi Guys I want to access from VPN clinet machine to VPN clinet machine. Can you please advise me how do i achive this setup.i have Remote VPN configured in ASA firewall. From VPN client to Corportate works fine however not able to access to VPN cli...
HI Can some one please help me to design the attached topology with the below condition?1) High availabity ( if 2911 goes down 2811 should pass all traffic)2) if primay wan down another wan servie should route all traffic3) if one switch is down anot...
Hi Phillip
Thanks for your reply. I am sure the code which i am running should be supporting stacked vlan. But command is not available.
Does it related to bootstrap image?
I am running below.
ROM: System Bootstrap, Version 12.4(4r)XD5, RELEASE ...
Hi Philip
The below is the code i am running on 7206 vxr npe-g2.
c7200p-advipservicesk9-mz.122-33.SRE14.bin
PE1(config)#int gig0/2.14 PE1(config-subif)#encapsulation dot1Q 14 se PE1(config-subif)#encapsulation dot1Q 14 ? native Make this as nat...
yes i read those link. i did remove the dial peer and added again no difference. even i try removing the voice service voip. still no luck.
i think the issues hit the below bug. have a look. i am trying to move to T services image will see how it wil...
guys i see the same behaviour on my cube. not binding the ip what i have specified on dial peer. it take from other interface which is not bind in global setting to.
this is my post ..
https://supportforums.cisco.com/discussion/13041286/cube-bind-i...
i did remove the global binding and under dial peer then applied inside dialpeer.
no global binding at all. i am using only inside the dial peer only facing to carrier but the bind ip is taking the interface which facing to our internal network.
tri...
