Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
We're testing ISE2.2 with AnyConnect 4.4 and ISE Compliance module 4.x for VPN.
Everything works as expected except for something that i am not sure if we're missing something or this is what the system can do.
When we do client provisionin...
Hello Community,
I have searched very hard to find info on that matter, but with almost no result, so I've decided to post a thread here. Our environment is based ISE 2.2 ASA 9.4 and AnyConnect 4.4
As you know there are two separate version "trains...
Hello,I am working on a jabber project consisting of:CUCM 9.1.2Colaboration Edge (MRA)CUCM IM&PJabber clients (mostly jabber for windows, mostly Windows XP workstations)Because of the fact that most of the end users are still on Windows XP we need to...
Hello,I ran into a situation where I need to connect 3 separate VRFs on a single ASR to a single firewall. Within those 3 VRFs are the branch VPN infrastructures of 3 separate tenants (subcompanies within a larger organization). The idea is that thos...
Hello all,we've recently migrated from IOS SSL VPN + AnyConnect to IOS XE IKEv2 + AnyConnect. It works fine, but users are missing the auto-reconnect feature. Both after intermittent internet drops and after system suspend/hybernate. Even though we e...
Meanwhile I found the solution. The right way to go on ISR1k is BDI. Looks like this:interface GigabitEthernet0/0/1 description === INSIDE === no ip address negotiation auto service instance 1 ethernet encapsulation dot1q 102 bridge-domain 102 ! s...
I have submitted a TAC case for that and the answer is as follows:I did research this further and as it turns out, currently the auto-reconnect feature is not yet supported yet on ASR. This is on the roadmap and is scheduled to be included in the up...
I've just noticed that a second warning had come up:The OpenDS service has stopped unexpectedly and has been restarted. If the problem persists, contact your TANDBERG support representative.which is really critical compared to the NTP one. And again...
BTW, prior to finding your solution i had another idea that would also work. But i am not able to figure out how to implement it on a Cisco router.If i configure both destination and static NAT for the traffic it will work. Meaning:Outside client wit...
Ah I see,maybe that's the problem. The router is 2921 IOS:Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(4)M2, RELEASE SOFTWARE (fc2)I will try later on with the debug.
