Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe are trying to register our local Cube router in Webex calling but the gateway keep going offline. When we enrol the gateway it goes online for few minutes and then it goes offline. The cube has a public ip address that is use for the connector.
Im trying to get the Room Bar register to CUCM but i keep getting the following errorSIP registration failed: 404 Not Found / Unable to find device/user in database. Verify SIP configuration and connectivity to SIP proxy.The device pack has been uplo...
Im not sure if this still work with the iosxe 17 but the eem applet is not triggering. Se below.track 99 ip sla 99 reachabilityip sla 99icmp-echo 10.10.10.1frequency 5ip sla schedule 99 life forever start-time now event manager applet testevent syslo...
dot1x debug:Mar 29 16:04:01: %SWITCH_QOS_TB-5-TRUST_DEVICE_DETECTED: cisco-phone detected on port Gi1/0/10, port's configured trust state is now operational.Mar 29 16:04:04: %DOT1X-5-FAIL:Switch 1 R0/0: smd: Authentication failed for client (1833.9D1...
Yes CDP is enable on the port. Same issue when i change it to multi-auth.GigabitEthernet1/0/10 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 0056.2b21.e58a (bia 0056.2b21.e58a)MTU 1500 bytes, BW 1000000 Kbit/sec, DLY ...
the CUCM and CUC is integrated properly, I already have 10 sites connected to CUCM and CUC using a Voice gateway. The only difference between the 10 site in the site that I'm having issue with is that it has CUE ISM installed and it was converted fro...
