Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello brains trust, I'm looking for some advice or guidance about how to approach a change from POTS to SIP. Currently there are 5 CME systems located at 5 office locations. There are SIP trunks (via WAN) between each system for internal calls, all e...
Hi Community,
I have a pair of ASA5516-X both with support contracts, and both are being managed by a virtual FMC running on VMWare.Now I have an issue with FMCv I need TAC support on, and I'm wondering does anyone know if FMCv is covered under the...
I've got a tricky problem which is a little difficult to solve.
The setup:
SITE 1 SITE 2
------ ------
C2821 ---- WAN ---- C2821
CUCME 8.6 CUCME 8.6
CUE 7.0.5
...
Remove 'ip nat outside' from your WAN interface (let the Dialer handle it). interface Ethernet0
description -- Ethernet WAN --
no ip address
pppoe enable group global
pppoe-client dial-pool-number 1 As for suggestions for improving your config, s...
I too am running 6.3.0-83 (which I upgraded to shortly before the holidays).
Now I see 6.3.0-84 was released, but FMC won't allow the upgrade from 6-3-0-83 to 6.3.0-84 to be applied:
Attempting to run the update creates this error:
But wait, my...
Is it possible to terminate the IPSEC part of the tunnel on a ASA, and then have a router attached to the inside interface to terminate the GRE tunnel? If so, how would the ASA have to be configured to achieve this?
