About achinthap

achinthap · 10-05-2016

Thanks a lot Chintan.

achinthap · 10-05-2016

So PIM1,PIM2,PIM3 of PGDUPLEX in my case will be used for both sides A and B?

achinthap · 10-05-2016

Ok, so my setup would as below;with one PG SideA PIM1 -> CUCM1 PIM2 -> CVP1 PIM3 -> CVP2 SideB PIM1 ...

achinthap · 10-04-2016

I have configured using one PG, 4 PIMS. How can I get the CVP-B status up?It's showing partial.

achinthap · 10-04-2016

So, Can't we point one side A vru pim to CVP-A and side B vru pim to CVP-B?

achinthap · 10-04-2016

Thanks Chintan, So how does the CVP load balance, if both vru pims are pointing to a single CVP host...

achinthap · 10-04-2016

Thanks Chintan. So for each side, PG1A / PG2B the peripherals should have unique PIM IDs right? It c...

achinthap · 10-03-2016

Hi All, I am setting up a duplex UCCE environment and while setting up PGs, I see that I am unable t...

achinthap · 09-15-2016

Thanks. So how can we access the configuration manager to do configs in Call Server?

achinthap · 09-15-2016

Thanks Chintan for the valuable information. So same concept applies if we have AW in Call Server Pr...

achinthap · 09-15-2016

Changing the AW Pointer to Public interfaces worked. Thanks a lot Chintan. Could you please tell me ...

achinthap · 09-14-2016

Also I am confused about the Administration & Data Server Connectivity config. In my Call Server AW ...

achinthap · 09-14-2016

Thanks Sasikumar and Chintan. Sasikumar - I will send the logs. Chintan - I thought that it should b...

achinthap · 09-14-2016

Hello Chintan, Thanks for the reply. Kindly check the below snapshots for your queries. Data Server ...

achinthap · 09-01-2016

Hey, No I faced this issue when I tried to install CVP v11. When I tried to install CVP 10.5 in the ...