Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
i'm facing issues for the ISR4331 which the speed and duplex needed to hardcore to 100mbps and duplex full. It is running isr4300-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin version. It is connected to switches WS-C3850 version cat3k_caa-univ...
I have query about the version 6.0.2.N1.2.bin? Can I straight upgrade the version from 6.0.2.N1.2.bin to 7.1.5.N1.1.bin? Any command important command that I can run to check the VSAN and SAN setting on the customer nexus switches? I worry about afte...
I have encounter issues with prime and is slow and will logout. Sometimes it took 30 minute to login to the prime GUI. When I check the ade# on cisco prime there are still leave 77GB of space for a total of 117GB which is understandable still have re...
I have encouter this issues on the Cisco prime from the customer. Need help to troubleshoot this collection failure issues. Althought is a small issues but customer need verification. Below the capture data for nexus and primeSoftwareBIOS: version 08...
Hi, I am facing this issues with Cisco Prime if using the prime to distribute the IOS software to model C1900, it will sometimes generate this issues device flash not have a flash card while it is clearly have a flash card installed. There is some C1...
Hi George,Yes it is half duplex. What it is happening? Do you need to shut and unshut the port? so far I have hardcode it to duplex full and change the speed.
Hi Andrea,I have successfully upgrade from 6.0.1 to 7.1.5 version. But need some clarification, The VSAN FC port need to reboot again for FC port to be able to detect? I thought when upgraded the version it should be went smoothly, never thought of t...
Thanks! andrea for information. Do you know what is the common command that is helpful to check all the SAN status and brief information. Appreciate for the reply and helps!
