Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,Our company have a Cisco PI 2.1 system, I want to monitoring some router's interface utilization.I followed cisco prime training course to set up some config in cisco PI, but it's seemed to be not effective.There's no result can be display...
Hi Expert, I got a problem recently, we have a stack switch with 4 * 2960X, we have a windows 2008 certificate server in our inernel network. But in this 4 switchs, when I connect my PC into the stack "MASTER" switch, the PC can get the "windows comp...
Hi All,Our office network setup is ISP-------ASA---------3750---------2960X (stack by 4)-----------wired usersRecently, I use command "show arp" in 2960X, the output as below,In arp table, I can't see wired PC mac address, and also I do a test at las...
Dear All,Our company have 100 users, in recent network was very slow, I log on edge router to show logging command, display as below:I want to know whether our network have some attack? and what should I to do?Our topology is: ISP------2900---------...
Hi All,Our company deployed Cisco ISE system to control PC clients access LAN.I have a question:I'd know a MAC address and I want to deny this MAC address to access our company LAN?What step should I do it?Thanks a lot !! BR Frank
Hi Afrjo,According to your method, I just try to run a report.But I didn't get the report that I want.The error display said "No data match the specificed criteria for the report"Did you come cross this isuss? Or what should I do to solve this issue ...
Hi Alejandro,Did you solve this problem? Or is it a bug?I face the some issue with you, I just run "Report/Report Launch Pad/Deivce/Interface Utilization"and then I create a report for interface utilization.But it display nothing when the report run ...
Hi Bro,Did you have a solution for it?The 2960 stack member switch also have some strange issue.I come cross some issue about cisco ISE cert, but the environment is similar to your.I have a stacking switch (4 * 2960X), in MASTER switch everything is ...
Hi Ali,You mentioned that at the same condition, you replace it by 3750, and then do not have this issue.I come cross a lot of strange issue on 2960X.Link as below,https://supportforums.cisco.com/discussion/12395181/need-help-cisco-ise-and-stack-swit...
