Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have an old 3640 router that I need to replace, the config is as follows:Cisco Internetwork Operating System SoftwareIOS (tm) 3600 Software (C3640-IS-M), Version 12.2(26c), RELEASE SOFTWARE (fc1)Copyright (c) 1986-2007 by cisco Systems, I...
Good day All;Sorry if this is a redundant question but in a week or two we are going to put in a secondary internetconnection. Is there a way on a pix 515E to have one internet provider be preferred over the otherand if the primary fails then the se...
I have a quick quesiton here and not sure if I'm doing this right but my corporate network folks gave me 2 ports on the core switch now I have2 server on 2 different subnets which is fine. the issue comes along is that my corporate network will not ...
I have pix 515E that a proxy server hits to go out to the internet. The issue Pix I have it set up that anything on the192.168.5.0/24 subnet gets NATTed to the public IP of 38.125.160.200 and all works find and all. The proxy server'sIP address is ...
I have a quick quesiton here in genernal when you set up an encryption domain for an ipsec tunnel the subnet maskof your encryption domain must match your source/destination subnet mask. So for example say you have a sourceof 170.132.128.0/24 and d...
LOL yeah I know it is a 512k frame relay circuit....this connection is just for price files an there is only like 6 users pulling these files I found out so there is no voice or video or any high bandwidth applicationon this. Like you said the WAAS...
I finally got in contact with my coworker in Hong Kong and got the specs....it is a a 512k with only 6 active customers so from that it appears what I have is good to go but minus the NME-WAE-502-K9 moduleas their is really no need for WAN optimizati...
so then I would add another interface in my pix and attached that to the secondary internet routerand run BGP between the primary, secondary and backbone router you are saying?
Sorry for the late response but we finally was able to test and all is good, they wouldn't let us do a trunk port so had to go with the second optionThank you for that!!!
