Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I want my ESXi host NTP sync to a cisco switch (3850) which is at present NTP sync with a Stratum 1 ntp server externally. is it possible to get stratum 1 time from cisco swtich then ? what config change requires on the switch to become a...
Hi All,
Recently during IOS upgrade in Cisco ASA pair (active/stby), users experienced partial outage after I failed over the traffic to secondary ASA, while upgrading the primary. Basically connection table didnt get replicated completly. So how t...
Hi All,
I am trying to establish VRRP group on vlan 244. However it seems in both router it stays as ACTIVE. The topology of the network as shown below
Router1 Router2
| ...
ASA/act# sh running-config failoverfailoverfailover lan unit secondaryfailover lan interface failover Vlan604failover polltime unit msec 200 holdtime msec 800failover polltime interface 1 holdtime 5failover replication httpfailover link statelink Vla...
Hi Philip,
Can you please send me some sample config to implement that, so that I can test it first ? or if you any article covers it
Regards,
Muhammed
Hi ashirkar,My buffer seems filler up verify quickly. I am using buffer size 4096 max-size 1500. if i increase the buffer size, is it going to impact on router performance ?
Thanks for your reply. I have found the problem.the model I am trying to upgrade do not support c3900-universalk9-mz.SPA.152-4.M6 rather c3900e-universalk9-mz.SPA.152-4.M6. Found the issue when testing in the lab.
