Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,If I were to purchase a switch from a broker, can anyone confirm If i can purchase support (IOS upgrades etc) and Warranty from cisco direct for that switch, please? Our current Cisco reseller has informed me its 6months+ on lead times fo...
Hi, We currently have 2 Data Centers that are connected via a 10GB Point-to-Point connection. We have recently acquired a secondary 1GB Point-to-Point connection for redundnacy. Data Centre (A) has 2 Nexus 9K switches that are connected in a VPC. Dat...
Hi, I need to apply a NAT configuration for an individual internal IP to be NATed to another internal IP, that is connected to a third party firewall that is situated in our DMZ. The TP firewall in the DMZ is expecting traffic from a specific IP with...
Please can someone clarify if a vpc vlan is a vpc vlan if its not configured in a vpc port-channel but still gets carried over the vpc peer-link? I have vlans that are not in port-channels in my existing network which is in a VSS setup. Do these VLAN...
Please can someone help me?!? I have attached a picture of the topology. Kit list:cisco Nexus9000 93180YC-EX x2cisco Nexus2000 N2K-C2348TQ x4 POC 1 is on vlan 228 192.168.228.11POC 2 is on vlan 229 192.168.229.10 Both of these servers are unable to t...
Hi Sergiu, The NAT configuration did work!! The third party we are connecting to have confirmed they can see the relevant packets from the correct IP. When connecting to the URL i was getting a 404 error and thought it hadnt worked, but the TP have c...
Hi Sergiu, Apologies for the late response, i have only just been able to reboot the network and get NAT enabled. Unfortunately the NAT configuration has not worked, it doesn't appear to be NATing the relevant IP.I have added the IP Proxy-arp command...
Thank you Sergiu, i really appreciate your input. I get the following message when attempting to configure NAT on the relevant interface:ERROR: NAT configuration Failed: aclqos: TCAM region is not configured. Please configure TCAM region and retry th...
Hi Sergiu, Thank you for your reply. So, when traffic is destined from Server A to TP firewall it will NAT to 10.170.2.53. Any other traffic that server A transmits will not get NATed as long as it doesn't traverse vlan 170 outbound? Also will no oth...
