I have two Vg224. And i use it only internal calls without CUCM. One of them 100,101....123, and another one 200,201,...213. Its working fine in own side. But i can not call from vg1 to vg2.
How to solve this issue?
Please, help!
I configured switch1 and switch3. Between switch1 and switch3 (via fiber patch cable) both access and voice vlan are working. But when i put switch 2 between sw 1and sw 3 voice vlan not working. Is it possible?
I used these commands.
!
write erase
reload
! after reload
conf term
!
hostname rtr_201!
interface FastEthernet0/0 ip address 10.22.33.201 255.255.255.0
!dial-peer voice 20 pots destination-pattern 200 port 2/0!dial-peer voice 21 pots destination-pat...