Internal calls between two VG224 without CUCM

[alimurtazo]

I have two Vg224. And i use it only internal calls without CUCM. One of them 100,101....123, and another one 200,201,...213. Its working fine in own side. But i can not call from vg1 to vg2. 

How to solve this issue?

Please, help!

[R0g22]

Are these VG's registered to CUCM either as SCCP or MGCP ? Do you have a log from either VG or CCM trace to look into ?

[alimurtazo]

---

@R0g22 wrote:
Are these VG's registered to CUCM either as SCCP or MGCP ?

---

No. Its not connected CUCM. Both Vg224 connected each other by LAN cable.

[R0g22]

What are you using , H.323 or SIP ? Share the configs please.

[alimurtazo]

I used these commands.

!

write erase

reload

! after reload

conf term

!

hostname rtr_201
!

interface FastEthernet0/0
ip address 10.22.33.201 255.255.255.0

!
dial-peer voice 20 pots
destination-pattern 200
port 2/0
!
dial-peer voice 21 pots
destination-pattern 201
port 2/1
!

end

this is my config. 

In the attachment vg224 config.

[R0g22 · Accepted solution]

So you are trying to call b/w two VG's over IP right ? You need a VoIP dial-peer on each VG pointing to the other one -

dial-peer voice 1 voip
destination-pattern XXXX
session target ipv4:Y.Y.Y.Y
codec g711ulaw
no vad

You can tweak the codec if need be. Since this is on your LAN, it should work fine.

[alimurtazo · Accepted solution]

Great job!

Its working.

Thank you for support!