Overview: We have 4 external routers each has two connections to multiple ISPs using BGP4. As our traffic is mostly outbound, we used static routes to load share/balance both circuits on each router. The IGP used is OSPF.Problem: Recently, we are e...

We have AS5400-HPX connected to ISDN and SIP carrier. We noticed that a single fax page (using fax passthrough g711 to the SIP carrier) takes at least 65seconds to complete. Over a regular TDM circuit, the same page is sent not more than 55seconds....

I am setting up a meetme conference on my CCM 4.0(1) lab. Unfortunately, it is not working. The server acts both as Pub and Sub (single cluster). It is only using SW for bridging. I added the Meetme pattern of 310[0-1] in the same partition of my...

I have 2 questions regarding transcoder in ccm4.0(1). A 2600 with nm-hdv is configured as follows:sccp local FastEthernet0/0sccpsccp ccm 192.168.20.85 priority 1!dspfarm transcoder maximum sessions 24dspfarm confbridge maximum sessions 6dspfarm!show ...

Is it possible to have 1CM to connect to 1GK using multiple trunks and zones? (e.g., trunk1 is created using GK and zone 123, and trunk2 is created using same GK but zone 456?)