Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As in the diagram, we have 2 core network link together via L3 transit VLAN. Network 1 has its own VTP domain and using PVST. Network 2 has its own VTP domain and using MST.We are in the midst of collapsing the Core into one. At the end of the day, t...
Hi.. im having 2 ACS 3.1 server. ACS01 (Primary) & ACS02 (Secondary). Recently we have moved ACS02 to another site and changed its ip address. When we do database replication from ACS01, we received error message saying that ACS02 has denied replicat...
Hi,Can dynamic vlan assignment works across WAN (ACS3.1 is in HQ site)?e.g. in HQ we have 2 VLAN mapped to SSIDs. This is not a problem as the ACS knows that VLAN 10 & 20 exists in the network and assign it respectively based on the Cisco ACS configu...
We have one central site with ISDN-30 Backup link (Cisco7507). There is a new site where using ISDN-2 as a backup is not feasible as the backup link of 128Kbps is insufficient.We are planning to get a 2620 route with ISDN-30 NM Module. Central site (...
Hi,I'm switching from radius to tacacs authentication via ACS3.2. Previously when i'm using radius, going to previledge mode uses the default $enab15$ as the username. Now when i configure using tacacs, i'm unable to go into previledge mode. It will ...
hi,Are you receiving the error message similar as below ? However, for my case the mac-address reported are from the same source...=============================================Feb 3 14:40:15.445 CCT: %STANDBY-3-DUPADDR: Duplicate address 10.99.10.4 ...
I didnt really get what you're trying to say. However just to share, below is part of my AP config. Both the wireless side and AP FE interface are configured with the same subinterface id. (VLAN 40 and 50).. This AP is then trunked to a switch which ...
Yes the AP have to manually configured vith the VLAN.. Thats what i've been doing.. Will be quite tedious if you have lots of APs and VLAN to configure.. So far i don't think the current AP IOS able to do that..
