hi,
I am using wireless Controller Cisco. After I create any VLAN in the interface, in the port number I can provide only one physical port number. Is there anyway I can include more than 1 port for the same VLAN.
Please help me in this.
Thanks
uv.
Hi,
I am using Air-CAP3702i-A-K9 access point with firmware file, ap3g2-k9w7-xx.153-3.JC and version 15.3(3)JC.(Autonomous mode)
Please tell if it is possible to enable/disable Transmit Power Control (TPC) in this mode. If not, what mode it will be i...
hi,
I have few cisco aironet accesspoints, that I converted to autonomous ap. Is there any ios command that i use to find out if the AP
1. 11ac or 11n
2. TXxRX streams 2x2 or 3x3
I found out one way is to give following commands
#int dot11 1
# spee...
hi,I am using SG300-10PP. Moved to L2 mode. I am trying to move an interface to trunk port and encapsulation as dot1q. But I am not getting a command for that.# int gi7# switchport mode trunk# switchport trunk encapsulationIt says 'unrecognised com...
hi,
I am using Aironet Autonomous 1252 AP. The version used is:
Cisco IOS Software, C1260 Software (AP3G1-K9W7-M), Version 12.4(25d)JA1, RELEASE SOFTWARE (fc1)
I want to disable 802.11n on 2.4GHz interface. Please tell the CLI command to do this...
hi Scott,
I couldnot find the LAG option. Attached is the screenshot. Do you think it is because of old firmware.
Incase, we enable LAG, the other side of WLC, do we have to keep another cisco switch? Will it be possible to enable LAG in few ports o...
hi Ric,
I can do that manually. But I am experiementing with some automation tools, for that I want to read what capabilities the device has. 'show controllers dot11radio 0' gives lot of unwanted information that I donot need. Please provide any co...
hi tim,That command is not supported in that model of switch. It is small business switch.------------------------------------#switchport trunk ?allowednative------------------------------------encapsulation option is not coming. --uv.
