'Transmit Power Controller' in Cisco Autonomous Access Point

[yuvaraj02]

Hi,

I am using Air-CAP3702i-A-K9 access point with firmware file, ap3g2-k9w7-xx.153-3.JC and version 15.3(3)JC.(Autonomous mode)

Please tell if it is possible to enable/disable Transmit Power Control (TPC) in this mode. If not, what mode it will be in.

Thanks in advance.

uv.

[Rasika Nayanajith · Accepted solution]

There is no TPC feature in autonomous mode AP.

Refer below document to see how you can configure power level on each radio

https://supportforums.cisco.com/document/50526/how-configure-and-verify-transmitted-power-level-aps

HTH

Rasika

*** Pls rate all useful responses ***

[yuvaraj02]

Thanks Rasika.