finding out 11ac or 11n access points

[yuvaraj02]

hi,

I have few cisco aironet accesspoints, that I converted to autonomous ap.  Is there any ios command that i use to find out if the AP

1. 11ac or 11n

2. TXxRX streams 2x2 or 3x3 

I found out one way is to give following commands

#int dot11 1

# speed ?

It list out mcs indices supported.

Please tell if there is any other single show command that gives the required info.

Thanks in advance.

--uv.

[Ric Beeching]

You can do a show controllers dot11radio 0 or show controllers dot11radio 1 which will give you info on each radio. 

Personally I would just google "Cisco <model> datasheet" e.g. Cisco 3700 datasheet top search result is this:

http://www.cisco.com/c/en/us/products/collateral/wireless/3700-series-access-point/data_sheet_c78-729421.html

Which provides all the info on what you've requested.

[yuvaraj02]

hi Ric,

I can do that manually. But I am experiementing with some automation tools, for that I want to read what capabilities the device has.  'show controllers dot11radio 0' gives lot of unwanted information that I donot need.  Please provide any command which does this minimum task.

--uv.