Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using a server vendor provided QSFP+ breakout cable (something like this) in which one end is connected to a 2U server and 2 out of other 4 ends need to go into a layer-3 device (remaining 2 are unused at this stage). I got a cisco 3560-X wit...
The Cisco CSR BYOL AMI available from AWS Marketplace has a 30 (automatic from marketplace) and 60 days evaluation period.
Does anyone know what happens after the evaluation period expires.Are there any kind of restrictions which are implemented on t...
Hi Guys,
I am unable to find the optical received and transmit power on my interfaces a Cisco 12K box running below version.
IOS (tm) GS Software (C12KPRP-K4P-M), Version 12.0(33)S10, RELEASE SOFTWARE (fc1)
Hardware details are as below.
NAME: "Ch...
Hi,
I have two route relectors in our network as of the best practices for implementation of RRs.They are configured to be totally redundant to each other.
However I can see everytime one of the route reflector goes down ,the PE routers have a traffi...
Hi,
I am really stuck at this one ,since I dont know the way ahead to check issues which could be causing the drops on my tunnel interface on the CPE for DMVPN. I have attached a brief topology overview of the connectivity.
Here lets consider one ...
Additional informationCisco IOS Software, C3560E Software (C3560E-UNIVERSALK9-M), Version 15.0(2)SE11, RELEASE SOFTWARE (fc3)Also as soon as I insert the 10G end of the QSFP breakout cable into the module, I see the follow error:*Jan 2 02:12:12.493: ...
Alright just found out
router#show hw-module subslot 4/0 transceiver 0 statusThe Transceiver in slot 4 subslot 0 port 0 is enabled. Module temperature = 32.199 C Transceiver Tx bias current = 70780 uAmps Transceiver Tx power = 2 dBm Transceiver Rx...
One more thing to add is that the physical interface from the spoke to the service provider PE does not show any drops.
psn-cr272-ce1#sh int MF4 | in drops Input queue: 0/75/6/0 (size/max/drops/flushes); Total output drops: 1 Output queue: 0/1000/0 ...
I have tried to answer you queries as below.Let me know if they help you.How to achieve routing between the ISP and the Spoke/Hub location routers. As there are 2 ISPs there will be 2 routes for the same destination IP(Hub), how to get failover from ...
Vimal,That's where I had my first question if Hubs (CPE) are connected to each other directly also.If yes ,then you can achieve ISP level redundancy .So even if ISP1 goes down ,the CPE1 DMVPN tunnel will remain up ,by Public reach-ability of its IP ...
