Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have just realized that the C3750 switch only seems to support 15.4 watts per port which isn't sufficient for the AIR-AP2702E-UXK9 to run a full power
Any help with increasing this would be very helpful, thank you in advance.
Ed
So I have a wireless bridge connecting two buildings and have a router on the non-root side to handle switchport trunking for AP VLANs. This router only routes and handles data only from the AP (REGULAR AP ..NO BRIDGE). So the problem is that the WAN...
I have 5 Cisco CAP3502E AP's running in autonomous mode. I am thinking about switching to Lightweight and using a controller. Any suggestions on which controller would work best. The reason I am considering switching from autonomous to lightweight is...
Hello,I have a Pint to Point bridge set-up with two cisco AP's, and I am having trouble passing multicast/broadcast traffic through it.Any one any suggestions?Thanks
OK...I have discovered something extremely weird, if anyone can help me with this I would really appreciate it.So I have a wireless bridge set-up with two Cisco Aironet AP's ( 3500 and 1200 ), on the 5Ghz radio interface.All 2.4Ghz (Dot11Radio 0) int...
Sure John, I will post the config soon.Even though the static nat entry fixed the issue. I would still like to understand why this was happening in the first place.Thank youSent from Cisco Technical Support Android App
I added a static NAT entry "ip nat inside source static tcp", with both the inside local & inside global addresses to the private address which was assigned to that WAN interface. This solved the problem.Don't know exactly why ssh wasn't allowed when...
I would definitely agree with stepen however if that doesn't work you can try flashing a ios image with the correct reg domain. I belive the restrictions are all in hardware and not software.Correct me if I'm wrong.Sent from Cisco Technical Support A...
I've had the same problem before and removing TKIP solved my problem...however you said you tried that......Sent from Cisco Technical Support Android App
Maybe this will answer your question.I guess you could use MPLS over VLAN.I guess, "less overhead" would be one key benefit.www.networkmagazineindia.com/200609/newsanalysis06.shtmlSent from Cisco Technical Support Android App
