Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a multi-tenant CUCM Cluster using a centralized SIP trunk to our carrier via Cisco CUBE. While looking through CCSIP messages debugs I noticed quite a few SIP Subscribe requests (from CUCM to CUBE) with an event type of presence. We are not ...
OK - that is somewhat consistent with my findings that the interface has to be up before setting the speed and duplex parameters. Not good for me as I am configuring devices for shipping, although I guess I could connect the interface to a switch po...
I had a similar problem when attempting to set speed and duplex on G0/0/2 with a GLC-TE sfp module installed. With the earlier module (GLC-T which is end of sale), simply turning off negotiation "no negotiation auto" would allow the speed and duple...
Thanks for this thread. I had a similar problem with a 4331, using a GLC-TE in port G0/0/2. Our WAN provider requires the link to be hard coded to 100/FULL which used to work fine with the GLC-T, but with the GLC-TE the speed and duplex commands we...
From the CLI you can find out exact license usage:show uccx cad license usageThis will return a report of how many licenses are in use out of the number you have installed. It will also give you a list of the IP addresses of the agents or supervisor...
Good deal - doesn't look like replication is your problem. So let's make sure I understand the symptoms: You have two 7940 phones registered with CM with the extension of 8774. You delete one of the phone records from Call Manager but when the pho...
