Tuan Nguyen

Thanks

Hi Joseph,4 routers each has 4 interfaces: 2 40G and 2 10G to make 2 rings Traffic A is only on 40G ...

I have a ring of 4 routers which I need to have 2 separate ring on the same devices. Thinking of run...

Have ASR 1000X, it's configured with g0 using vrf Mgmt-intf and works. Just don't know if there is a...

3850 doesn't boot automatically, even after boot system switch all flash:packages.conf in the config...

I'm testing the marking with a simple acl and class, but with Wireshark, all traffic dscp =0 . g1/0/...

I could not apply service-policy input on an interface of 3850 lanbase but can apply service-policy ...

Have only 1 interface to connect to a stack so no redundancy. Will have another interface open soon ...

Current 1 connection with this configinterface Port-channel4 no ip address!interface Port-channel4.4...

Thanks for the answer, George. That what I did but the phones were not working. Is there anything el...

When I change the name of the router, the phone stops working so I backed out. Realized that I have ...

May be I did not make it clear, based on the doc the 3945 has 3 GE interfaces. My question was "How ...

How many maximum GigEthernet interfaces I can use at the same time on the base model (without extra ...

Having question on ISR 2921 G2If I installed SM-ES3G-16-P’s in my 2921, could they perform all the f...