Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just had a quick design question to get further insight on.
We have small enterprise campus with about 80+ switches. Currently we setup vlans per closet that are trunked back to the core and have vrf's per function and route between VRF's.
Examp...
I went to install a 7811 and found out that this was not a supported device.
However we have other 78xx(7821,7841,7861) phones in our 9.1 call manager environment.
Do I really need to install a device pack just for this one phone? Could I just insta...
Our marketing department has decided to begin inserting messages for upcoming events onto the default on hold music and has started wanting this changed every week. As far as I can tell this is a manual process to change the .wav file that is used.
...
below is my config that i am testing with.ip access-list extended testdeny ip host 192.168.72.2 192.168.25.0.0 0.0.0.255permit ip host 192.168.72.2 anyint vlan 10ip address 192.168.72.254 255.255.255.0ip policy route-map 857route-map 857match ip addr...
Switches: 3560routers: 2811AP: 1552eWe have 4 1552 AP's that we would like to setup in a point to point environment. Currently they are light weight but we would make them autonomous for this scenario, unless there is a feature in the controller that...
I am currently running 5520's running 8.4.100 code. Up to this point I have seen no reference about this version. Has Cisco abandoned this?
Our plan is to get to 8.5 fixed release when it comes out. I just thought it was odd that I haven't seen any...
JB,
Thanks for the follow up. I mean to ask that design question. This was setup before I started at this location, so I am not sure as to why this was configured this way. But, I will plan to make this design change. Thanks again for the advice.
JB,
Thanks again for you assistance. I proceeded as discussed and the install went well with very minimal downtime if any.
The primary for our phones is the PUB.
As a test, I created an ACL for my phone blocking access to the PUB and was able to se...
JB,
Yes this helped. One answer I have not been to clear on is actual downtime. My assumption is that following the steps users should not experience any downtime. Is my assumption correct?
- install file on both pub/sub
- go to software defaults an...
Thanks for the reply an confirmation.
Just to have an idea, what kind of downtime should I be expecting assuming I put back the firmware versions for the phones so that they do not need to restart?
Thanks
