Hi Folks Wonder if you could help have an ISR 4331 with an SFP (SFP-GB-GE-T) in interface G0/0/2. It is set for auto negotiation and negotiates to 100M/Full duplex to an ADVA NTE. Although the interface comes up I am seeing CRC errors. The circuit th...
Hi Folks,
The command to track a route is
track <track number> ip route <ip address> <mask> reachability
This assumes that the route is in the global routing table.
What if you want to track a route that is in a VRF. There does not appear to...
Hi Folks,
I have an IR809. The router has two GiEthernet ports which I believe are L3 interfaces. Do you know whether they can be setup as switchports?
I wish to put both ports in a VLAN and setup a L3 VLAN interface on the router but I don't thi...
Hi
I have a router where the same ACL is applied across several interfaces.
I would like to know the ACL counts/matches for each individual interface. Is this possible?
I don't believe it is but would appreciate your views.
Look forward to h...
Hi Folks,
Can you help.
Have a 819HG-4G router. Running IOS 15.3(3)M.
When I try to create an LTE profile the IOS does not allow me to set the pap/chap username and password for the APN. Any idea how this should be set.
The exec command gives the...
Hi I have managed to implement a workaround for the problem by swapping the SFP interface for a RJ45 interface on the router. I could not get the SFP interface to work with the ADVA NTE. I tried the SFP-GB-GE-T and Cisco GLC-T. The ADVA NTE (FSP 150...
Yes the interface is clocking up CRC errors. We have swapped the cables. In fact we disconnected the cable from the ISR and connected it to a test router with a GigE RJ45 interface and we had a clean connection so I can only assume that it is the SFP...
Thanks for the reply.
The output of
show interface g0/0/2
is
GigabitEthernet0/0/2 is up, line protocol is upHardware is ISR4331-3x1GE, address is 00f2.8bd0.3c72 (bia 00f2.8bd0.3c72)MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,reliability 131/...
