Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi TeamI am exhausting my current 4 digit VoIP dial plans and soon need to implement New VoIP dial plan keeping in mind the existing dial pattern My DID numbers are different then my VoIP numbers e.g 6666 9202 and voip :- 1202 Currently i am thinkin...
Hi AllI want to add EPABX in CUCM (10.5) , i want IP Phone to dial out using the EPABX , Any suggestions or the same and how to go about it Thanks in Advance
Hi Guys I am having issue in incoming call in SRST Jun 24 12:10:23.944: ISDN Se0/1/0:15 Q931: RX <- SETUP pd = 8 callref = 0x0029 Sending Complete Bearer Capability i = 0x8090A3 Standard = CCITT Transfer Capability = Speech ...
HiI have Ip phone, connectivity as follows IP Phone-- CUCM ---CUCM has PRI-QSIG with EPABX -- ROUTER IS registered as MGCP Gateway the Location analog phone and Ip phone have same series numbers e.g. 3001 (analog) 3002(IP Phone) But when i call via I...
HII am not able to receive incoming call via my PSTN , Also i am not able to dial local call via my PSTNI am able to dial STD and ISD calls but not able to receive incoming from STD,ISDCUCM:- 10.5 Please find the traces Dec 29 06:47:55.227: ISDN Se0/...
No i want to keep the existing dial pattern with addition of 2 more digits so that i get more numbers e.g. 25XX change to 1125XX so in short user will have to dial 6 digits for VoIP but i need to add the extra 2 digits in such a way that the existin...
Hi TOnyI am planing more than 20 sites and i want to retain my 4 digit numbers and add 2 more numbers to increase the digit count to 6 so that my numbers at each site would increase
Yes we are having 4 digit VoIP dialing Plan between the locations and now we are exhausting the dial plan and finding it difficult to expand for the new VoIP series dial plan :- 10XX, 12XX,13XX,14XX,15XX,16XX,17XX,18XX,19XX, 20XX, 21XX ....... 99XX ...
Hi TonyThe translation is done by EPABX for DID to VoIP and it sends 4 digits from EPABX to CUCM The CSS reaches the DN directly The current dial plan is of 4 digits between the locations Hope i answered your queries
Hi TonyThere is SIP trunk between CUCM and my EPABX EPABX is doing the translation of DID with VoIP extns. in CUCM we create dial pattern The point here is i am checking one location as test case whose series is from 1000-1999 and even if i convert t...
