Hi,
I have below configuration in the RPS 2300
Router1#sho env rps RPS Name: RPS 2300 State: Active PID: PWR-RPS2300 Serial#: FDO2107PG07 Fan: Good Temperature: Green RPS Power Supply A: Present PID : C3K-PWR-1150WAC Serial# ...
Hi,
Regarding the table attached, I can not support a massive outage of my 6 CS2921 connected to the RPS2300, is that correct?, why?, it doesn't make sense I'll need almost one to one RPS-router.Thanks in advance!
Laura
Hi,
I need to configure a Cisco1941sec/K9 as XOT device and as well this router will create the IPSec tunnel to transport the XOT traffic over a VPN tunnel.I've been checking different posts and it's not very clear if the router can have both roles, ...
Hi,We have installed Cisco Prime 4.1 and we have discovered all the devices of our network. Although all devices appear as known both in Monitor and in Inventory, some of them are not being monitored correctly.For example, in the Known_Device_List Re...
Hi,I wonder if it is possible to get an availability report of an AP's group through the WCS, not for all the APs of the group, but for the group.Thanks in advanced.Best regards,Laura Herrero
Hi,
Yes, I had the same idea, that it should work, but then I tripped over with the following post where said "Not sure if the XOT router can also be the IPSec endpoint,"
https://supportforums.cisco.com/discussion/9323671/encrypting-xot-using-ipsec
...
Hi,The resolution Name-IP is correct, since in Inventory you can see this correlation; but when the LMS shows an alarm or event in the Monitor part, the LMS shows another name (in fact, the previous name that had the device). This just happens for a ...
Hi,I stopped the daemon manager, copied the file you send me into D:\CSCOpx\objects\smarts\conf\discovery and then restarted the daemon manager, but the devices are not being discovered yet.By the way, I checked this new config file you have sent me ...
Hi,Where is this DFM config file you have suggested? I found out that OID 1.3.6.1.4.1.9.1.1027 is for catalyst3750v248ps, is this correct?The CM has been already updated to the latest packages and it doesn't recognize the 2960S devices...Cheers,Laura