Hi
I'm just after confirmation, please, that Collaboration Applications deployed as VMs - i.e. CUCM, UCX, etc - are discovered using SNMP and that nothing else needs to be done?
Thanks
Nigel
Router A is an ASBR in a NSSA. Redistributing routes from RIP into OSPF which includes a default route.Router B is the ABR between the NSSA and Area 0. It receives all the redistributed routes as LSA Type 7.Router C is another ABR between Area 0 and ...
I have a customer who is requesting a set of translations to mirror the setup on his current PBX.The customer dials #61xx and that gets translated to a full E164 number. Customer uses this to hid the full E164 number from end users and publishes to t...
Customer has CUCME 8.1 and has asked if the last number dialed when call forwarding all can be retained in memory?So customer call-forward-all to 07967111111. He then removes this call forward. Later he wants to again call-forward-all to the same num...
Okay, so I've almost completed my first CUCME instal and the customer has requested non alphanumeric logins for extension mobility. For the life of me I can't find any documentation noting how this can be done.So can it? And, if so, how?Nigel
Thanks for the comprehensive answer Robert.If I may I would like to run a scenario by you.I need the 1000v to apply QoS marking to traffic from VMs - one marking for voice RTP stream and one for voice signalling from the same VM. So would I then be a...
Hi RobertI have a question around the use of the VIC card on a blade where the Nexus 1000v is also installed. Is the 1000v able to levarge any of the abilities of the VIC? i.e. if I have segmented the VIC up into several NICs with specific QoS settin...
Hi JonRouterB is connected to RouterA via fastethernet.Could you advise what sections of the config you would like to see. The configs are large and would take some redacting in order to preserve the customer's security.Nigel
So earlier than expected I've managed to get the following. The OSPF config on RouterB -router ospf 100 router-id 192.168.250.2 log-adjacency-changes area 20 authentication message-digest area 20 nssa passive-interface default no passive-interface Vl...
