Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I'm trying to use vlan tagging for the AP-2602 access port to join the WLC.
VLAN-Tagging is enabled for the AP (WLC setting) and the switchport as tunk.
AP won't access the right VLAN.
Work when I change the switchport to access-mode, acces...
Hi all,
Has somebody found some kind of workaround here?
Kind regards,
Norbert
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuy89100/?referring_site=bugquickviewclick
Symptom:Jabber iPhone users cannot hear the first 2-3 seconds of audio after t...
Hi allI'm trying to configure a SNR on a CME (7.1). Internal incoming calls are working, external incoming call are not.Here the configuration.ephone-dn 26 dual-line number 726 no-reg primary label xxx(726) description xxx name xx mobility snr 5726...
It’s on the WLC / Wireless / Detail for AP / Advanced / VLAN TaggingVLAN Tagging SettingsVLAN TaggingVLAN tagging of the CAPWAP packets that you can enable or disable.Trunk VLAN IDID of the trunk VLAN.If the access point is unable to route traffic th...
The AP is in local mode.
I know that the AP need's only one vlan to connect with the wlc.
As the AP's area are not secure, I want to tagging the "access-vlan" from AP view.
E.g. somebody diconnect the AP network cable an put the laptop on it, it will...
