Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,
I am getting error "SCCP Admin State: DOWN"
call manager IP 10.106.97.240
Please suggest how to fix the issue.
R3925#sh running-configBuilding configuration...
Current configuration : 4283 bytes!! Last configuration change at 13:...
Hi Everyone,
I am trying to setup lab with two h.323 VG each one in a different cluster. one is 3925 router and the other one 2900 route with E1 PRI connected on both the router.
CUCM1-->10.106.97.240
router 3925-->10.106.97.200
Phone 1:- 5555--->SEP...
Hi Every one
I have got 2900 router and trying to enable E1 port. Not able to configure the same.
by going through the document found UCK9 type should be in EvalRightToUse but on my router it is RightToUse.
is this cause of the issue.
Hi Everyone
I am trying to make call from phone A cluster 1 to phone B cluster 2.
Call hits the Phone B and will click speaker button there is no audio and in phone A can hear call ringing tone, and the call gets disconnected after 8 seconds.
I have...
I will go to the lab and try to connect the physical phone and do a test. Is there anything need to look for in codec configuration in router or cucm?If even physical phone fails is there anything I need to look for?
