Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The snapshot feature looks like a very interesting and useful feature to use but I'm having problems in two different boxes with different NX-OS versions, the error is basically the exact same error:
I have tried in nxos.7.0.3.I6.1 and nxos.7.0.3.I2...
I have been trying to boot the N9kv in VMware following the steps in NX-OSv 9000 for in the section for VMware "Provisioning the NX-OSv 9000 in the ESXi Hypervisor, for the most part the description is very similar to what we can configure but I'm ha...
I have been trying to boot the N9kv in VMware following the steps in NX-OSv 9000 for in the section for VMware "Provisioning the NX-OSv 9000 in the ESXi Hypervisor, for the most part the description is very similar to what we can configure but I'm ha...
Is there any way to prevent using EEM a command from taking place using N9k, let say that I want to prevent changes on the interface Eth1/1, something like this should work:event manager applet test
description "do not modify Eth1/1"
event cli matc...
I've been trying to configure and understand how VXLAN/EVPN and Symmetric/Asymmetric IRB work together. My question is exactly about this link VXLAN Network with MP-BGP EVPN Control Plane - Cisco and the paragraph just above Figure 5
As shown in Fig...
Hi @Brandon Rumer (Cisco)
I tested your solution and I was able to make it work, but there is one caveat, I cannot use a dvswitch, not sure what happens but the device is able to boot and once it boots the ESXi gets disconnected from the network, aft...
I haven’t tried but that would not automatically increase the filesystem of the hard-drive, in that case I will still have a disk full. I will try and I’ll update the case, thanks.
