Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys and gals, I have been struggling with this one for a couple of days now and need some help. I am running NCS 1.1.24, and 7.2.110 on both my MSE and WLC. The WLC is synchronized with the MSE and my NMSP is active. Anyone ever seen this issue...
Is there a quick and easy way to deny specific users access to their quarantine. I have some users who we don't want them releasing their email from quarantine or even logging into their quarantine. Just a general thought but you could restrict use...
I have always understood that by default sysopt connection permit-vpn was enabled by default on ASA 7.2 and above and therefore by default exempted traffic flow between hosts in the crypto ACL from having to be parsed against your ingress or egress A...
I am fairly familiar with hardening of Cisco routers acting as an internet gateway, like enabling SSH and blocking inbound access to private range IP addressing via ACLs, disabling , but what about switches? Is there a best practice on configuring ...
I have created sub interfaces in the past and applied access-lists to each sub interface. However, is it possible to apply a single access-list to the parent interface with rules referencing multiple sub interfaces in that access-list?Thanks in adva...
I have a similar problem but in my case the 3850 is running 03.02.03.SE IP Base and will not accept the ip policy route-map command on the VLAN interface. Do I need to IP Services running to support a per VLAN i?
Thanks...
Scott, I can't find any information on this other than this particular thread. I upgrade 1.4 to 2.2. Controller is on 7.6.110. I get this error. Check the logs is sorta frustrating because I'm not sure which log this would be under and their ar...
"Hi Andy, it depends on the setting. But indeed most settings on a WLAN configuration would require the AP to turn down its radio and turn it back on again immediately. So since it has to flap the radio, yes it affects all WLANs. This is when the set...
Hello Nicolas. Quick one here.When I make WLAN changes on a controller it resets all the WLANs. This is an H-REAP AP. Does a configuration change on an H-REAP WLAN force a reset of the entire H-REAP AP?Thanks...Andy