Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
G'day,Planning to upgrade our Cluster to 8.6(1a). Cluster consists of several MCS 7825-H3 (HP OEM). I noticed the following on Page 5 of Release Notes for Cisco Unified Communications Manager Release 8.6(1a):"If you are upgrading software on HP7825H3...
G'day,I have a few new MCS 7835-i3 which are made by IBM. As you can imagine there are many differences between these and the HP manufactured MCS's that I am familiar with. Particularly the only way I can get the RAID 1 array to rebuild is when MCS i...
G'day,I have a question regarding SIP Trunk configuration/capability. My SIP trunk is configured with Media Termination Point Required. When configuring the MTP Preferred Originating Codec if I choose 711alaw does that mean that G.728 will also work ...
Hello,I have EM running with PIN. Is there a way to automate the EM Login process in the following manner:EM enabled SCCP Handset not logged in -> User logs into PC connected to Handset -> EM automatically logs in as a result of PC loginIs this possi...
Use Navigation to open 'Cisco Unified OS Administration'.Login using the System user/pass.Click Show -> Hardware.One of the Hardware Resources listed will be Serial Number.The attached image shows what the output looks like.
Hi Steve,I would like to use SIPP for some performance testing on CUCM. Could you please share your CUCM and SIPP config for this particular test you have described?Thanks in advance,Col
Upgrade to 8.6 worked just fine once I formatted the 16GB USB device to ext2.Now if only I could work out how to rate this answer to my own question and close the Discussion
