Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Techs,
I have a Cisco PE Cisco7200 and Huawei CPE with double tagging on sub interface at PE. Huawei CPE has subinterfaces with dot1q termination vlan id (each subinterface has particular CE vlan id applied).
The problem is with BGP session un...
Hi Guys,
We have a pair of Nexus7k's up and running since 200+ days. We used putty for console access and since last couple of days we are seeing issues in putty like delayed output, no typed inputs etc. When we tried with flow control as "none" th...
Hi Techs, Could you please help with the SNMP V3 configuration on ISR4321 for Entuity NMS tool. The ISR is discoverable via SNMP V1 or V2c. I have below commands on the router and the device is getting certified but there are no interfaces or data pr...
Hi All, We have a Cisco C3650-48 port in stacking and in L2 only mode (no ip routing) with default gateway set.There were static routes entered (not sure why) and may be by mistake. Since then we are seeing stale static routes with AD 0 in the show i...
Hi Guys, I have been seeing BGP standalone/ distributed mode in show bgp ipv4 unicast sum command. Would like to know if there is any document which describes the concept or could someone please explain the same. Thanks a lot! Regards,Santosh
Hi Mark, We have tried all that. Currently we do not have static routes, ip routing is disabled (no ip routing) and default gateway set. But still we are seeing those static routes. The weired behaviour is, why any ping done from the switch installs ...
Hi Peter, Thanks for the quick reply. The cocern was raised as customer has couple of servers in the /24 subnet which were impacted due to reverse traffic getting blackholed due to routing on L2 stack. The same /24 subnet is used on the L2 stack for ...
