Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI want to create an interface utilization report for a specific port group in PI, but can't see how to do that in the report setting. You only seem to be able to select a specific device or site rather than port group. Is it possible? Also, is i...
HelloI am testing a script where I want a conditional registration line based upon the existance of an environment variable. The script below measures txload on one interface, but is supposed to measure txload on a second interface IF the environment...
HelloPlease can someone tell me the correct syntax for this registration on IOS XR 4.2?::cisco::eem::event_register_stat name ifstats-datarate modifier_1 Gi0/3/0/2 modifier_2 InputPacketRate entry_op gt entry_val 100 exit_comb and exit_op ne exit_val...
HelloIs it possible to do this on IOS XR?IOS config : R14(config)#mpls traffic-eng R14(config)#mpls traffic-eng auto-tunnel primary onehop R14(config)#mpls traffic-eng auto-tunnel primary config mpls ipIOS-XR 4.2doesn't seem to have the ability to cr...
HelloCan someone with experience of 6PE please clarify a question for me?The following doc says that 6PE allocates aggregate labels for BGP prefixes from a pool of 16, which are used in a round robin fashionhttp://www.Cisco.com/en/US/products/sw/ioss...
HiYou just need to add some CLI commands to do something (if that is what you are asking? if [catch {cli_open} result] { error $result $errorInfo } else { array set cli1 $result } if [catch {cl...
I also see it to. I'm not sure it is a problem as there have been no complaints, but the overruns are there on one of my devices as you say GigabitEthernet117/1/0/2 is up, line protocol is up (connected) 0 input errors, 0 CRC, 0 frame, 3623878656...
have some issues with multicast forwarding out of interfaces on which an IGMP join was received? inside the PIM network, I don't see this RP/0/0/CPU0:XR8#RP/0/0/CPU0:Oct 17 12:30:25.552 : netio[310]: MFIB-ingress: Failed to set deliver list in pak - ...
I have had this problem. I opened a TAC case via our support provider for this, who could only point me to this thread!A few weeks ago when testing the 6807-XL with FEX, I managed to reboot the device before the FEX image downloaded, which wiped off ...
