How does multiple (e.g. 4) analog phones connected to a single FXS port, via splitters, affect the impedances seen by the FXS port and would this be considered against "Best Practice"?Thanks.
How does multiple (e.g. 4) analog phones connected to a single FXS port via splitters affect the impedances seen by the FXS port and would this be considered against "Best Practice"?Thanks.
I am looking for a tail utility for Windows 2000 (preferable command line) that would allow viewing of traces file on lab CCMs.Any recommendations?Thanks.
To simulate a call on on a Cisco IOS router.#csim start eg. csim start 4000.This is a undocumented command which make crash your router so use with caution.To debug the call setup;For voice ports;#debug vpm signalFor ISDN;#debug h225 q931 Hope that h...
I did a quick search of Cisco's site but I did not find anything. Personally, I have not done this setup before but I will do a quick setup in the lab to confirm. I'll let known the outcome.
Have you tried Multilink interface?I.e. 1.Create a Virtual multilink Interface.2. Assign brige-group to multilink interface3. Apply rtp header compression on interface4. Assign bridge group to physical interface.This should work, in theory.
Have you tried Multilink interface?I.e. 1.Create a Virtual multilink Interface.2. Assign brige-group to multilink interface3. Apply rtp header compression on interface4. Assign bridge group to physical interface.This should work, in theory.
