Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying to connect a Cisco 3750-48 to a Brocade ICX6450 switch.
********************************************************************************************************************************Cisco IOS Software, C3750 Software (C3750-IPBASEK9-M...
It has been a while since I checked on these switches. Is it OK to now use the 15.0.2-SE6 IOS or should we continue to stick to the 12.2.58-SE2 version?
We have very simple configurations on our switches (small offices on an MPLS WAN link) that come to our HQ office for Internet access. Our switches are all 3560X switches running 12.2(58)SE2 - IP-BASE CRYPTO.My question are these. 1. Some switches ...
Is it advisable to update to the 15.2.1E1 IOS for these devices or should I stay on 12.2(58)SE2 and 12.2(55)SE3 IOS? I know 15.0.2 had issues. Also, I have two 3750E-48TD switches that are on IOS 15.0(1)SE or SE2. Should I go ahead an update them?
We have Cisco Catalyst 3750X-48T-S Switchs in our environment. Currently, all are loaded with the 12.2.58-5E2(ED) IOS. Review of the available IOS's for these switches shows two possibilities. The 12.2.58-5E2(ED) IOS was last updated in July 27, 2011...
The working for a while meant 15-20 minutes. We then tried to setup vty security and that broke it. We are now testing with a different Cisco switch connected to a different Brocade switch to start form scratch to get a working configuration. so f...
Mismarked as correct answer. How do I uncheck that?
Here are the responses for the commands you listed.
1. show spanning-tree vlan 7
Spanning tree instance(s) for vlan 7 does not exist.
2. show spanning-tree interface fastEthernet 3/0/48
Vlan ...
Sorry it has taken so long to respond. Tied up with other issues and priorities. I've attached the "show running" configurations for both switches.
Are both systems using the same Spanning-tree method?
This could be one of the issues. The Cisco ...
Looks like the new version (3.1.04059) fixes the issue. I was able to log in to my VPN and reboot my PC with no problem. Thank for all the work and sticking to the problem until resolved. This is the way it is supposed to work.Thanks to all.
Has Cisco made any comments about this issue? Seems strange that they are not aggressively seeking an corrective solution.Sent from Cisco Technical Support iPhone App
